Backing Pad 32mm PSA Soft, 5/Pack

Backing Pad 32mm PSA Soft, 5/Pack

Female no hole PSA soft backing pad with an even surface.
Backing Pad 70x198mm Grip 56H Medium

Backing Pad 70x198mm Grip 56H Medium

Grip backing pad for orbital sanders. Delivered with one pad protector and user instructions.

Backing Pad 77mm 1/4" Grip 6H Medium

Backing pad medium for grip disc, delivered with one pad protection disc including user instructions.

Backing Pad 77mm 1/4" Grip Medium

Backing pad medium for grip discs.

Backing Pad Net 125mm 5/16" Grip 28H 130g Medium

Fits all Mirka 150 mm (6”) sanders. This 130g backing pad gives you the ability to switch sizes and use 125 mm (5”) sanding discs.

Backing Pad Net 150mm 5/16" Grip 48H Medium

A 150 mm (6”) backing pad with a central air inlet. The air channels leading to the center of the backing pad has an increased air flow and therefore the dust is removed efficiently.

Backing Pad Net 150mm 5/16" Grip 51H Med

Backing pad medium for net discs. Delivered with a pad saver and user instructions.
Backing Pad Net 200mm 5+8 Screws Grip 25H

Backing Pad Net 200mm 5+8 Screws Grip 25H

This 200 mm (8") grip net backing pad is suitable for Dynabrade, Hamach and Rupes machines. Dynabrade machines require 5 screw holes. Before assembling the pad on a Dynabrade machine apply the yellow sticker on the Mirka label. Rupes and Hamach machines require 8 screw holes. The pad is ready to be assembled.
Backing Pad Net 200mm Grip 89H Medium

Backing Pad Net 200mm Grip 89H Medium

This 200 mm (8 in.) Net Backing Pad with 89 holes is unique and designed only for MIRKA ROS2-850CV two-handed randon orbital sander.
Backing Pad Quick Lock 32mm PSA Soft, 10/Pack

Backing Pad Quick Lock 32mm PSA Soft, 10/Pack

Quick Lock pad 32mm PSA soft. Suitable for Mirka® ROS 150NV, Mirka® AOS 130NV, Mirka® AOS-B 130NV and Mirka® AROS-B 150NV sanders

Backing Pad UNI 150mm 5/16"+ M8 Grip 61H Medium

Abranet medium density Unipad 150 mm (6") for all hole combinations. This Abranet unipad is optimized for flat surfaces and has a high edge durability. 15 larger holes allow use of conventional discs with 6 h, 6 + 1 h, 9 h and 15 h. Suitable for narrow shroud machines but not recommended to be used with 150 mm ROS machines, because the combination of Unipad + wide/Abranet shroud machines does not give the optimal dust extraction. Delivered with one 150 mm (6") pad saver. To ensure correct installation, always use the supplied spacing washers, making sure that a minimum gap exists between the sander’s shroud and the top part of the backing pad, to prevent friction between the two parts. Tighten the screw hard. The backing pad should never turn idle. From time to time, check that the screw is well tight.