Unipad Ø 150 mm 5/16" + M8

Unipad, 5/16" and M8. Suitable for narrow shroud machines.

Delivered with one 150 mm (6") pad saver. To ensure correct installation, always use the supplied spacing washers, making sure that a minimum gap exists between the sander’s shroud and the top part of the backing pad, to prevent friction between the two parts. Tighten the screw hard. The backing pad should never turn idle. From time to time, check that the screw is well tight.

Note that these backing pads are not recommended to be used with 150 mm Mirka® ROS machines, as the combination of Unipad and wide/Abranet shroud machines does not give the optimal dust extraction.

Technical details

Diameter
150 mm
Screw
5/16" + M8
Unipad Ø 150 mm 5/16" + M8Unipad Ø 150 mm 5/16" + M8Unipad Ø 150 mm 5/16" + M8