First of all, check and make sure there are no air leaks in the line, and that your compressor is producing 17 CFM at 90 PSI, the recommended pressure.
If the air supply is adequate, check that the pneumatic tool is properly lubricated - it needs to be oiled to perform best.
When the tool is noticed to be running slower, add 1-2 drops of oil into the air inlet. Do not add too much oil. Only lubricate pneumatic tools.
Please note that in some countries the full version of myMirka and Bluetooth are not available. Mirka® DEOS Electric Sander 1. Connect the power cord to a mains outlet. 2. Press and hold the rpm+ button while switching on the power button. 3. The left LED starts blinking, to indicate that Bluetoot
Random orbital sanders are designed to be used with specific sized pads, with a precise weight. Make sure you are using the correct size pad, and that it is in good condition. Changing your backing pad when necessary will keep the vibrations of your sander to the minimum. Large chunks of missing pad
Over time, the cables on Mirka DEROS, DEOS and LEROS tools might break due to wear and tear. To address this matter, Mirka shifted from molded cables to cables with rewireable connectors on these tools. This means the cable connectors can be changed by the user themselves, without need for special t
The DEROS Random Orbital Sander has not been designed for polishing. For polishing work, we recommend the following tools: Battery powered polishing tools AROP-B 312NV 77mm ARP-B 300NV 77mm Pneumatic polishing tools ROP2 312NV 77mm ROP2 512NV 125mm RPS 300CV 77mm AP 300NV 77mm Electric polishing too
